Components test

Automotive Engineering

Passive Safety Solutions: components tests

Analysis of safety belts by the Regulation ECE R14

Analysis of door locks by the Regulation ECE R11

Analysis of seats by the Regulation ECE R17

Wheel steering analysis:

chest impact analysis by the Regulation ECE R12
head impact analysis by the Regulation ECE R12

Dash panel and interior analysis :

dash panel analysis by the Regulation ECE R21
dash panel framework analysis at abrasion of airbags
dash panel analysis by knee zone of driver by EuroNCAP

Fuel system analysis by the Regulation ECE R34

Last news

New version of PRADIS 4.4.900

22.10.2007

In the new version 4.4 the preprocessor ...

The project for fuel tank engineering is finished

13.08.2007

for "DetalStroyKonstruktsia", Inc.
CFD analysis is used for engineering of new fuel tank ...

Conference CADFEM – 2006 (20-21 April)

23.04.2006

LADUGA took part in conference CADFEM–2006. The conference was in Moscow, Russia. The main problems of conference were CFD and strength. LADUGA presented report Optimization of passanger compartment framework by using linear static methods.